![]() The popup menu in the size tab contains some useful functions for setting the size of the document. The third option is to use the center of the current document boundary and expand or contract the new size evenly on all sides of that point The difference in between Center Current and the default Center Content is that the former refers to the center of the drawing regardless of what it contains and the latter to the center of the objects contained in the drawing. The second option is arrange the existing objects so that the origin of the user coordinates is centered in the document. ![]() The first option in the popup is to change inward to or outward from the corner with the lowest x and y values, normally the lower left. The default is to move the graphic center of the objects in the drawing to the center of the new size. ![]() For the PDF output to match a standard size, the drawing area needs to be 50% smaller than it would be if the output was at normal size.Ī change in document size can shift the contents in several ways based on different reference points. For example, you can increase the standard 1/4" scale to 1/2" by exporting a PDF scaled at 200%. This is done so that the document, when output at this percentage, will be the desired size. A standard document size selected from the popup menu will be increased or reduced if the PDF Scale value is not 100%. When a document is exported as a PDF it can be scaled at 200%, 50%, or to the current zoom. Factors that affect the size include the margin settings as well as paper size and scale selected with the Page Setup button. The current zoom changes the size of the printed output. The page size shown is for the document zoomed to "Actual Size". The drawing size can also be set in terms of the pages it will take to print. Standard sizes are available in the Select Size popup. This tab is also used to set the size of the drawing area. This information appears in the header of a report when it is printed and in generated title blocks. The document properties tab has two parts: Setup and Coordinates.ĭocument Properties/Setup lets you edit basic information about the plot. The Inspector Panel -> Document Properties Tab
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |